Target Segment
  • High-end workstation, server, and internet application
Form Factor
  • ATX
  • Size: 12" x 9.8" (W x H)
Processor Support
  • Dual Intel® Xeon™ processors up to 2.80GHz with 512K L2 cache
  • Intel E7505 chipset
Front Side Bus
  • 533/400 MHz
  • Up to 8 GB ECC registered DDR-200/266 memory in 4 DIMM slots*
  • Supports registered ECC memory and unbuffered ECC/non ECC memories.
  • Two-way interleaved memory banks provide outstanding memory performance. (must use a pair of DIMMs for memory to function)
    (Memory recommendation list)
I/O Expansion
  • 1 8xAGP Pro 1.5V
  • 1 64-bit 133MHz PCI-X
  • 1 64-bit 100MHz PCI-X
  • 2 32-bit 33MHz PCI
Onboard Devices
  • Dual EIDE ports support Ultra DMA 100MB/s of Burst data transfer rate, supports UDMA Mode 5, PIO Mode 4 and ATA/100
  • Intel 82545EM Gigabit Ethernet controller
  • 1 Floppy
  • 2 Fast UART 16550 serial ports
  • 1 ECP/EEP parallel port
  • Up to 6 USB2.0 ports
  • PS/2 keyboard and mouse ports
PC Health Monitoring
  • Monitoring the voltages of the CPU core and the status of system power supply (+1.8V, +3.3V, + 5V, ± 12V)
  • CPU/chassis temperature monitoring
  • CPU fan auto-off in sleep mode
  • CPU overheat LED header (front panel)
  • chassis intrusion detection (through LDCM) 
  • Support for system management software (LDCM)
Standard Retail Package
  • One SUPER X5DAL-G mainboard
  • CPU retention SKT-095-604E, SKT-120 and clips
  • 1 three-ended 80-wire/40-pin IDE UDMA/100 ribbon cable for high speed UDMA IDE devices
  • 1 floppy ribbon cable
  • One BIOS/drivers CD
Special Features
  • Suspend to RAM (STR): All tasks are stored in RAM and can be resumed within 10 seconds from the minimum power consuming suspend mode.
  • Wake-on-LAN allows for remote network management and configuration of the PC, even in off-hours when the PC is turned off. This reduces the complexity of managing a network.
  • Onboard 3-phase switching power regulator supports CPU core voltages from 1.1-1.85 volts
  • 4  tachometer fan connectors (for CPU, chassis, and thermal control fans)
  • Keyboard wake-up from Soft-off
  • Connector for LED overheat indicator
  • Overheat backup fan connector for CPU protection
BIOS Features
  • Supports ACPI (Advanced Configuration and Power Interface) and APM (Advanced Power Management)
  • Slow blinking LED for Sleep State indicator
  • Main switch override mechanism. Power-up mode control upon recovery from AC power loss
  • PC Health Monitoring protects your system from problems even before they occur.
  • DMI support
  • External modem remote ring-on when system is in Soft-Off state
  • BIOS rescue hot keys for rescuing BIOS chip from flash failure
  • Hardware BIOS virus protection
  • 4Mb Flash ROM
Other Features
  • Internal/external modem ring-on
  • One WOL (Wake-On-LAN) connector
  • One chassis intrusion connector
  • Chipkill support
  • CPU thermal trip support
Chassis Compatibility
  • Extended ATX Chassis
  • Chassis Guide
  • To ensure system stability, a 400W (minimum) ATX12V power supply (besides the 24 pins, both 4-pin and 8-pin +12v power connector) is required.
  • Please check Support for more details

Information source: Supermicro, Inc.
All product information on this site is based solely on information made available by the respective vendors,
other products and companies referred to herein are trademarks or registered trademarks of their respective companies. Twin Micro, Inc.  disclaims any responsibility for this information or the products listed or any typo error. Product information may be inaccurate and is subject to change without notice. You should contact the vendors with any question about the products or the information presented.

Copyright © 2003 Twin Micro, Inc. All right reserved.
For any comment, please contact