Target Segment
  • High-end server
Form Factor
  • Extended ATX
  • Size: 12" x 13.05" (W x H)
Processor Support
  • Dual Intel® Xeon™ processors up to 2.80GHz with 512K L2 cache
  • Intel E7501 chipset
Front Side Bus
  • 533/400 MHz
  • Up to 16 GB ECC registered DDR-200/266 memory in 8 DIMM slots*
  • Supports only registered ECC memory. Non-ECC or unbuffered memories are not supported.
  • Two-way interleaved memory banks provide outstanding memory performance. (must use a pair of DIMMs for memory to function)
I/O Expansion
  • Total: 6 PCI-X slots
  • Max up to 3 64-bit 133MHz PCI-X

Default setting:

  • 3 64-bit 100MHz PCI-X

  • 3 64-bit 66MHz PCI
  • 1 VXB (Virtual Extended Bus)
Onboard Devices
  • Support Intelligent Platform Management Interface (IPMI) ver. 1.5 option 
  • Dual EIDE ports support Ultra DMA 100MB/s of Burst data transfer rate, supports UDMA Mode 5, PIO Mode 4 and ATA/100
  • Intel 82546EB dual port Gigabit Ethernet controller
  • ATI Rage XL 8MB PCI graphic controller
  • 1 Floppy
  • 2 Fast UART 16550 serial ports
  • 1 ECP/EEP parallel port
  • Up to 5 USB ports
  • PS/2 keyboard and mouse ports
PC Health Monitoring
  • Monitoring the voltages of the CPU core and the status of system power supply (+1.8V, +3.3V, +5V, ±12V) 
  • CPU/chassis temperature monitoring
  • CPU fan auto-off in sleep mode
  • CPU overheat LED header
  • LED and control for chassis intrusion detection
  • System resource alert
  • Support for system management software
Special Features
  • Wake-on-LAN allows for remote network management and configuration of the PC, even in off-hours when the PC is turned off. This reduces the complexity of managing a network.
  • Onboard 3-phase switching power regulator supports CPU core voltages from 1.1-1.85 volts
  • 6 tachometer fan connectors (for CPU, chassis, and thermal control fans)
  • Keyboard wake-up from Soft-off
  • CPU frequency settings - changeable in BIOS setup
  • Connector for LED overheat indicator
  • Overheat backup fan connector for CPU protection
  • IPMI (Intelligent Platform Management Interface) 1.5 option
  • LDCM (LANDesk Client Manager)
  • LDSM (LANDesk Server Manager) option
  • Super Doctor software (optional)
  • DMI support
BIOS Features
  • RTC (Real-Time Clock) wakeup
  • External modem remote ring-on when system is in Soft-Off state
  • BIOS rescue hot keys for rescuing BIOS chip from flash failure
  • Hardware BIOS virus protection
  • Phoenix 4Mb Flash ROM
Other Features
  • ACPI/APM power management
  • Internal/external modem ring-on
  • Control of power-on mode for recovery from AC power loss
  • One WOL (Wake-On-LAN) connector
  • One chassis intrusion header 
  • Chipkill support
  • CPU thermal trip support
Chassis Compatibility
  • Extended ATX Chassis
  • Chassis Guide
  • To ensure system stability, a 350W (minimum) ATX12V power supply (besides the 20 pins, both 4-pin and 8-pin +12v power connector) is required.
  • Please check Support for more details
Standard Retail Package
  • One SUPER X5DPE-G2 mainboard
  • CPU heatsink retention and clips
  • 1 three-ended 80-wire/40-pin IDE UDMA/100 ribbon cable for high speed UDMA IDE devices
  • 1 floppy ribbon cable
  • 2 Fan-042 with heatsink
  • One BIOS/drivers CD

* This product has been designed to support 2GB DIMM modules for each memory slot, but it has only been validated on 1GB memory modules.

Information source: Supermicro, Inc.
All product information on this site is based solely on information made available by the respective vendors,
other products and companies referred to herein are trademarks or registered trademarks of their respective companies. Twin Micro, Inc.  disclaims any responsibility for this information or the products listed or any typo error. Product information may be inaccurate and is subject to change without notice. You should contact the vendors with any question about the products or the information presented.

Copyright © 2003 Twin Micro, Inc. All right reserved.
For any comment, please contact